Step 1: Our Drop Down Nipple Shields are made a little different then most you see on the market. We make the little loops a little bigger to allow larger gauge barbells to pass through. They can accept 10g barbells without a problem, but if you have an 8g, with some work you can pass one through. (Try at your own risk)

Step 2: Here is a closer look at the Nipple Shield Design with the Barbell through it.

Step 3: Place the Nipple Shield over your Nipple and line up the two loops with the holes in your Nipple.

Step 4: Press the Shield against your breast or chest and slide the barbell through your piercing.

Step 5: Screw on the other ball and your good to go. The barbell will hold the shield in place.

 

Step 6: Another picture of what the final result looks like.

Step 1: Our Nipple Shields are made a little different then most you see on the market. Since we don't use little holes that the barbell slides through, our Nipple Shields can be worn with any size barbell. From 18g up to whatever..

Step 2: Here is a closer look at the basic concept behind our Nipple Shield Design. There are two indentions that the barbell lines up with, which holds the shield in place.

Step 3: Place the Nipple Shield over your Nipple and make sure the two indentions on the Shield line up with the holes in your Nipple.

Step 4: Press the Shield against your breast or chest and slide the barbell through your piercing.

Step 5: Screw on the other ball and your good to go. The barbell will hold the shield in place.

Step 6: Another picture of what the final result looks like.